Lacner3D Printing Services Egypt-3D Printers Egypt Store

Photosensitive Resistor

A high-quality LM393 voltage comparator is used in this Photosensitive Resistor Dependent Control Sensor Module. The comparator output signal produces a clean and excellent waveform when employing the sensitive type photosensitive resistance sensor.

With a 15mA driving capability and an adjustable potentiometer, the brightness of the light detected may be adjusted. The working voltage ranges from 3. 3 to 5 volts. Where output refers to the output of a digital switch. Because this module is light-sensitive, it is commonly used to detect ambient brightness and light intensity.

DO output is at a high level when there is no light or when the light intensity cannot achieve the value. The module DO output is low when the light intensity exceeds the value. The module's digital output DO can be directly connected to a microcontroller, which can detect high or low levels, allowing it to monitor changes in ambient light intensity.

You can use this board as a photoelectric switch or as a digital output DO port driving relay module (our store sells these relay modules). The analog output is connected to the ad module, which uses the ad-converter to obtain a more precise light intensity value.

Pin for the interface:

1. +Ve power supply (VCC).
2. GND stands for Ground.
3. D0 refers to the digital output signal.
4. A0 stands for Analog Output Signal.
5. Strong light, LED light, modest output.
6. The light is dim, the LED is turned off, and the output is set to a high level.
7. The sensitivity can be changed.

Specifications:

1. LDR module 4 PIN
2. Operating voltage 3.3V-5V
3. Signal output indicator light.
4. LDR module 4 PIN
5. Able to detect ambient brightness and light intensity Adjustable sensitivity (via blue digital potentiometer adjustment)

Features:

1. It comes with a Mounting Hole Screw.
2. Easy to install
3. Signal output indicator light.
4. LDR module 4 PIN
5. Able to detect ambient brightness and light intensity Adjustable sensitivity (via blue digital potentiometer adjustment)
6. Output: DO digital switch output (0 and 1), AO analog voltage output Compatible with Arduino, Raspberry, and other microcontroller boards.

Feel free to buy from our store.